ep

January 20, 2021

Electrical power UNITS FOR LIFT TABLE 1
Standard Description
This power unit is developed solely for that small lift table,Consisting of high stress gear pump, AC motor, multi-functional manifold, valves, tank, etc. This electrical power unit has been extensively made use of within the industry of logistic products for example minifork lift, scissors lift and ariel functioning platforms. The lower-ing motion is managed through the solenoid valve with all the pace managed by the adjustable needle valve.
Energy UNITS FOR LIFT TABLE 2
Basic Description
This electrical power unit is intended solely for the medium lift table, Consisting of very effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering motion is actived from the solenoid valve along with the speed managed through the adjustable needle valve. Once the lift rises to a high positoin, however the electrical power provide is reduce, the decreasing movement is controlled through the manual override perform.
Energy UNITS FOR LIFT TABLE three
General Description
This energy unit is intended solely for that significant lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived by the solenoid valve and the speed managed by a strain compensated flow control valve.
Power UNITS FOR LIFT TABLE four
Basic Description
This power unit is developed solely for the big lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived by the solenoid valve and the speed controlled from the adjustable needle valve. Once the lift rises to a substantial positoin, but the energy provide is lower, the decreasing movement is controlled through the manual override perform.
Specific Notes
1. This electrical power unit is of S3 duty cycle, which could only perform intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean all of the hydraulic components concerned in advance of installation of the energy unit.
three. Viscosity of the oil shoud be 15~46 cst,which ought to also be clean and cost-free of impurities.N46 hydraulic oil is recommended.
4. Oil changing is needed just after the preliminary a hundred operation hours,afterwards the moment each 3000 hrs.
5. The power unit shown is created to be mounted vertically.